Removing the broken touch panel of a ux

[doug104231]

nope im still rockin the solo

[ceehoppy1st]

Here's an old pic of a UX touchpanel 0520002014.jpg
If you have to do this again, use a thin tool to gently pry the sides of the metal frame out a little, & the touchpanel will unclip from the lcd (makes it easier & safer to cut the panel off.) You could probably get some thin Lexan sheet (hobby shop), cut it to UX size & glue it to the panel frame. clip it back in place- it would probably work better than a screen protector.

I always wonder why none of the online shops ever sell 4.5" touch panels. There have been some that were close in size, but were only 80% transparency- that makes the UX screen look grainy & fuzzy. There are some that still sell the "complete" lcd (but not the touchpanel) & they usually have a minimum order of 5, or 10, or 50 units. oh well

[doug104231]

well actually you cannot remove the panel with a little tug cause of the adhiesive but maybe with some sort of solvent

[blaster]

i think i want a silver casing.

[blaster]

i have a blue one.

[bigs]

I have blue, black and silver, hehhehee